Komatsu — 21.5 SPLIT FLANGE CONNECTIONS

21. STANDARD TIGHTENING TORQUES 21.3 HYDRAULIC TUBES AND FITTINGS The torque figures are recommended for plain, cadmium or zinc plated fittings, dry or wet installations. Swivel nuts either swaged or brazed. Figures are for tube nuts used with 37” flared fittings and JIC - 37” seat O-Ring boss plugs and swivel nuts. 21.4 HOSE CLAMPS 21.5 SPLIT FLANGE CONNECTIONS The following chart provides the tightening torques for hose clamps used in all rubber applications (radiator, air cleaner, operating lever boots, hydraulic system, fuel systems etc.). The following chart provides the tightening torques for split flange connections used in hydraulic systems.

Flanges and fitting shoulders should fit squarely. Install all bolts, finger tight, then torque evenly. Over torquing bolts will damage the flanges and/or bolts, which may cause leakage.

I TORQUE f 0.6 Nom (5 Ibf in) CLAMP RADIATOR, AIR HYDRAULIC SYSTEM FLANGE SIZE BOLT SIZE BOLT TORQUE TYPE AND CLEANER, BOOTS, SIZE Nom Ibfft Nom 1 Ibf in 20 to 24 15tol8 II 314 I 318 1 30 to 37 1 22 to 27 11 112 5/l 6 Worm Drive - 1-X in Open Diameter and Under T Bolt 6.2 to 7.3 55 to 65 -_--_ 2.2 to 3.3 20 to 30 4.5 to 5.6 40 to 51 l-l/4 7116 47 to 61 35 to 45 1 318 37 to 47 27 to 35 l-l/2 II2 62 to 79 46 to 58 II 2 I l 75 to 88 1 55 to 65 11 Worm Drive - Over 1-X in Open Diame- ter 4.5 to 5.6 40 to 50 Worm Drive - All Ultra-Tite 10.7 to 112 95 to 105 4.5 to 5.6 40 to 5( 3-l 8