24. SERVICE PROCEDURE 24.10.1.3.4 Compressed Air A WARNING Wear eye protection when using air under pressure to clean parts. Limit air pressure to 206 kPa (30 psi). REMARK Do not tap the element against a hard surface; this will damage the element. 1. Carefully tap the side or end of the element against the palm of your hand to remove loose dust. 2. Direct clean dry compressed air up and down the pleats on the inside of the element. Always direct the flow of compressed opposite the normal operating air flow direction through the element. 3. Inspect the element for damage. 24.10.1.3.5 Inspection 1. Inspect the filter element for leaks or damage by placing a bright light inside the element.
Inspection of the element on the outside will disclose any holes where concentrated light shines through. The slightest rupture requires replacement of the filter element. 2. Inspect the contact surfaces of the air cleaner body. If faulty or damaged surfaces are noted, correct these conditions immediately. 24.10.1.3.6 Installation 1. Insert the open end of the primary element (4) into the air cleaner body and secure with the wing nut and gasket (3). Install the cover (2) onto the air cleaner body. Secure with the wing nut (1) making sure the cover is not cocked. 2. Inspect and tighten all air cleaner connections before resuming operation. Start the engine.
If the air cleaner filter service light continues to show air flow restriction, replace the primary or primary and safety filter element. 3-52