Komatsu — 24.10 PERIODIC

24. SERVICE PROCEDURE 24.10.1.4 SAFETY FILTER ELEMENT 24.10.1.4.1 Service Replace the safety element with every third change of the primary element or when plugged, as shown by the service light. 24.10.1.4.2 Removal 1. Remove the primary filter element, refer to 24.10.1.3 PRIMARY FILTER ELEMENT. 2. Remove wing nut with gasket (1) and remove the safety element (2). Clean the inside of the body with a damp cloth. Check the condition of the gasket on the end of the safety element. If the gasket is damaged or missing, replace the element. w 24.10.1.4.3 Installation 1. Install the new safety element in the body and secure with wing nut and gasket. 2.

Install the primary element over the safety element and secure with wing nut and gasket. Install the cover and secure with the nut making sure the cover is not cocked. 24.10.1.5 DUST VACUATOR VALVE The dust vacuator valve will automatically remove dust and water from the air cleaner. To function, the vacuator valve lips must point downward and be kept free of debris. The lips should be closed except when engine is idling slowly or stopped. If the vacuator valve is lost or damaged, replace it to maintain the air cleaners efficiency and normal element service life. 24.10.2 CLEAN FUEL TANK STRAINER This screen filters the fuel entering the tank and eases the job of the fuel filter.

Remove and clean the screen with a nonflammable commercial cleaning solvent. 3-53