24. SERVICE PROCEDURE 24.11.3 ETHER START 24.11.3.1 PRECAUTIONS A WARNING Ether starting fluid is highly flammable. Follow the precautions on the container. An explosion can result if sparks or flame contact the ether or if the container is stored where the temperature exceeds 49°C (120°F). Observe the following precautions: Do not use the ether injector when the air temperature is above freezing. Do not smoke when using ether starting fluid. Do not store fluid containers in the operator’s compartment. Store the containers in a cool, well-ventilated place. Keep the fluid containers out of the reach of children. Do not breathe the hazardous ether vapor.
Do not let ether contact you skin, because it can cause frostbite. Never puncture the fluid container or put it into a fire. Dispose of empty containers properly. For your safety, remove the ether container when welding, grinding, or using a torch on the machine. Follow the correct method for starting the engine, see 12.2.2 COLD WEATHER START- ING. REMARK Improper starting fluids can cause valve seizure and severe damage to the engine. Consult your distributor for the recommended starting fluid to be used. REMARK The ether starting valve inlet must be sealed against the entry of dirt at all times by having a fluid container installed or by installing the dust cap provided with the valve.
24.11.3.2 INSPECTION AND CLEANING Make certain that ether is available under pressure. To do so, remove the ether container and check if a good spray is obtained. If not, replace with a new container. If a good spray was obtained, reinstall the container and test the ether injector as follows: Disconnect the ether tube at the spray nozzle in the engine manifold. Remove the spray nozzle. Reconnect the nozzle to the tube. Direct the nozzle away from the engine and actuate the ether injector. Dribbling or no spray indicates a blocked spray nozzle or tube. If necessary, clean or replace spray nozzle and/or tube. Install the new fluid container in the plastic housing.
Secure the container in place by threading it into the valve. r IN STORAGE IN USE 24.11.3.3 CHANGING THE FLUID CONTAINER 1. Unscrew the plastic fluid container housing from the ether starting valve. Remove fluid container and check condition of o-ring. Discard the empty fluid can in a suitable, closed refuse container. 2. 3-61