Komatsu — 24.11 WHEN REQUIRED

24. SERVICE PROCEDURE 1. Remove the bolts and track adjuster cover. 2. To increase track tension, connect a lubricator nozzle to the lubrication fitting (2). Determine the amount of adjustment necessary, and add lubricant to obtain the proper track chain tension. It is advisable to move the machine forward and backward slightly to be sure the correct tension has been obtained. 3. To reduce track tension, loosen the bleeder valve (3) % to 1 full turn to allow the pressurized lubricant to escape through the relief passage.

If lubricant does not appear, loosen the check valve (4) (located under the lubrication fitting) % to one full turn to allow the pressurized lubricant to escape from a second relief passage. 4. If lubricant still does not appear, use the following emergency method. Should the relief passages still be blocked, unscrew the ball check and/or relief valve an additional I-% to 2 turns (2-X total turns). This will allow a greater amount of pressurized lubricant to free the passages. A WARNING Use extreme care when relieving pressure with the following emergency method. If loosened excessively, the ball check or relief valve can be ejected by the cylinder pressure.

NEVER loosen these parts more than a total of 24 turns. 1 5. When the proper tension has been obtained, tighten the ball check and/or relief valve to value given below. Install the cover and secure with removed hardware. REMARK u Ball Check or Relief Valve: 68 Nern (50 Ibf ft ) Never remove one link to bring a stretched track to within the range of proper track adjustment. A track that is worn badly enough to take up the length of one link, will be so far out of pitch that the increased wear on the sprocket will far more than offset the saving obtained by the removal of one link in the track chain.

24.11.8 ADJUST FRONT IDLER CLEARANCE Measure gap A and add shims (1) to obtain a 0.152 to 0.762 mm (0.006 to 0.030 in) clearance (A). Equalize gap B on both sides of the front idler. Measure gap C and add shims (2) to obtain a 0.152 to 0.762 mm (0.006 to 0.030 in) clearance (C). Repeat steps 1 and 2 for remaining front idler. L 3-65