Komatsu — 24.12 SEASONAL PREPARATION

24. SERVICE PROCEDURE 24.12 SEASONAL PREPARATION 24.12.1 GENERAL Proper maintenance and mechanical efficiency is enhanced during seasonal air temperatures changes, when the following instructions are followed. 24.12.2 OUTSIDE SOURCE OF HEAT Machines left outside for prolonged periods in sub-zero weather will suffer from cold-soak. Lubricants become viscous and incapable of lubricating moving parts. Extreme wear could result to the engine, transmission and final drives unless proper precautions are taken. A source of outside heat is necessary under these conditions. There are electric as well as propane-fired engine coolant heaters available.

Gas-fired forced air heaters may also be obtained to heat the transmission and final drives. When using such, be sure to follow the manufacturers instructions for personal safety. instructions when using external heaters to warm the power train in cold weather. 24.12.3 LUBRICATION Lubricate and service your machine at intervals specified in 23.1 MAINTE- NANCE SCHEDULE CHART. Service performed at specified intervals will prolong the life of the machine. Refer to 20.1 PROPER SELECTION OF FUEL, COOLANT AND LUBRICANT. Always select oils and lubricants specified at Anticipated Air Temperature when making seasonal preparations.

24.12.4 FUEL SYSTEM For details of the fuel to use, see 20.1 PROPER SELECTION OF FUEL, COOLANT AND LUBRICANT. 24.12.5 COOLING SYSTEM Prepare the cooling system as follows: Check the entire system for leaks. Inspect the condition of all hoses and replace the hoses and hose clamps as necessary. Check the operation of the thermostat by observing the engine coolant temperature gauge on the instrument panel during operation. If the engine warms up slowly, the thermostat may be stuck in the open position. If the engine overheats, the thermostat may be inoperative by remaining closed.

REMARK If improper thermostat operation is indicated, refer to your Engine Shop Manual for removal and installation procedures. 3-66