Check Oil Level in Engine Oil Pan, Add Oil OPERATION The parts and oil are at high temperature immediately after the engine is stopped and may cause serious burns. Wait for the temperature to go down before starting the operation. Make sure that the machine is in a horizontal position before you check the oil level. 1. Stop the engine and wait for the temperature of all parts to go down. 2. Open the engine side cover on the right side of the chassis. 3. Take out the dipstick (G) and use a cloth to wipe off the oil. 4. Fully insert dipstick (G) into filler pipe (F) and then remove it. 5. The oil level should be between the H and L marks on dipstick (G).
If the oil level is below the L mark, add oil through oil filler port (F). If the oil is above the H mark, drain the excess engine oil from drain plug (P) and check the oil level again. If the oil level is correct, tighten oil filler cap (F) securely and close the inspection window. Remark If the engine has been running, wait at least 15 minutes after stopping the engine before checking the oil level. Make sure that the machine is in a horizontal position. WA250-6 2-79