Komatsu — Stopping the Machine

Stopping the Machine OPERATION Avoid stopping suddenly. Give yourself ample room when stopping the machine. Avoid parking the machine on a slope. If it is necessary to park the machine on a slope, stop the machine facing directly down the slope; fit blocks under the tires; and lower the bucket to the ground to prevent the machine from moving. If the work equipment control lever is touched by mistake, there is danger that the work equipment or machine may move suddenly and cause a serious accident or injury. Before leaving the operator's compartment, always set the work equipment lock lever securely to the LOCK position.

Even if the parking brake lever is pulled and set to the LOCK position, there is a danger of the machine moving until the parking brake pilot lamp lights up. Keep the brake pedal depressed. Remark Never use the parking brake lever to stop the machine when traveling, except in an emergency. Apply the parking brake only after the machine has stopped. 1. Release accelerator pedal (1) and then depress brake pedal (2) to stop the machine. WA250-6 2-105