3. Loosen two bolts (1) and adjust plate (2) so that the bottom edge is in line with the center of the sensing surface of proximity switch (3). Then tighten the bolts to hold the plate in position. OPERATION 4. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 to 0.197 in) between plate (2) and the sensing surface of proximity switch (3). Then tighten the nuts to hold in position. Tightening torque: . . . . . . . . . . 14.7 – 19.6 N•m (10.8 – 14.5 lbf ft) 5. After adjusting, start the engine and operate the work equipment control lever. Check that the lever is automatically returned to HOLD when the bucket reaches the desired height.
For details about returning the control lever automatically to the HOLD position, see “Operation of Work Equipment” on page 2-109. Adjusting Bucket Positioner 1. Lower the bucket to the ground; set it to the desired digging angle; and return the work equipment control lever to the HOLD position (b). 2. Set the work equipment lock lever to the LOCK position, then stop the engine. WA250-6 2-131