Komatsu — Bucket Level Indicator

OPERATION 3. Loosen two bolts (1); adjust the position of mounting bracket (4) of the proximity switch so that the rear tip of bar (2) is in line with the center of the sensing surface of proximity switch (3); then tighten bolts to hold the bracket in position. 4. Loosen two nuts (5); adjust so that the clearance between bar (2) and the sensing surface of proximity switch (3) is 3 to 5 mm (0.118 to 0.197 in); then tighten the nuts to hold in position. Tightening torque: . . . . . . . . . . 14.7 – 19.6 N•m (10.8 – 14.5 lbf ft) 5. After adjusting, start the engine and raise the lift arm.

Operate the work equipment control lever to the DUMP position, then operate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging angle. For details about returning the control lever automatically to the HOLD position, see “Operation of Work Equipment” on page 2-109. Bucket Level Indicator There are two level indicators at the top rear of the bucket. They check the bucket angle during operations. (A): Parallel with cutting edge (B): 90 degrees to cutting edge 2-132 WA250-6