Komatsu — Check Oil Level in Transfer Case, Add Oil

Check Oil Level in Transfer Case, Add Oil MAINTENANCE The parts and oil are very hot immediately after the engine is stopped and may cause burns, if touched. Wait for the temperature to drop before starting the work. Do this procedure if there is any sign of oil on the transfer case. Checking Oil with Engine Running Remark “When the warming-up operation of the transfer is completed” means the condition where the transfer oil temperature has been warmed up to a temperature of approximately 40 – 60°C (104 – 140°F). As a guideline, this condition is usually reached when the machine travels under its own power for 30 - 40 minutes.

If the ambient temperature is low (below 0°C (32°F), the transfer is warmed up when the machine travels under its own power for approximately one hour. 1. Start the engine and carry out the warming-up operation for the transfer. When the warming-up operation of the transfer is completed, run the engine at low idle for at least five minutes. 2. While the engine is running at low idle, open the cap of oil filler port (F). 3. Take out the dipstick (G) and use a cloth to wipe off the oil. 4. Fully insert dipstick (G) into the oil filler pipe and then remove it. The oil level differs according to the oil temperature. Check the oil level after completing the warming-up operation of the transfer.

5. The oil level should be between the A and B marks on the HOT IDLE side of dipstick (G). If the oil level is below the B mark, add oil through oil filler port (F). If the oil is above the A mark on the HOT IDLE side, drain the excess engine oil from drain plug (P) and check the oil level again. If the oil level is correct, insert dipstick (G) in the dipstick guide and then tighten the cap. WA250-6 3-33