MAINTENANCE 4. Set a container under the radiator (under valve (2)) to catch the drained antifreeze mixture. 5. After draining the coolant, close drain valve (2) and fill with tap water. 6. When the radiator is full, start the engine, and run it at low idle. Keep the engine running at low idle for ten minutes until the coolant temperature reaches more than 90°C (194°F). 7. Stop the engine; open drain valve (2); drain the water; then tighten it again. 8. After draining the water, clean the cooling system with cleaning agent. Follow the instructions provide with the cleaning agent. 9. Add the coolant and water mix through the water filler port until it overflows.
To determine the mixing ratio for the antifreeze and water, see “Water and Supercoolant Mix Ratio Table” on page 3- 31. 10. To bleed the air from the cooling system, run the engine at low idle for five minutes and for a further five minutes at high idle. (When doing this, leave the radiator cap off.) 11. Drain the coolant from subtank (3); clean the inside of the subtank; then add water until the coolant level is between the FULL and LOW marks. 12. Stop the engine and wait for approximately three minutes. Add coolant until the coolant level is near the coolant filler port. Replace the radiator cap and tighten it. 13. Check the coolant level and add coolant, if necessary. 3-32 WA250-6