Cleaning with Engine Side Cover Open MAINTENANCE 1. Stop the engine 2. Open the engine side covers on the left and right sides of the machine. 3. Remove mounting bolts (2) (two places at top) of condenser (1). 4. Hold the top of condenser (1) and tip it over to the front. 5. Insert the steam jet nozzle through the gap between the radiator, oil cooler, aftercooler (3), and the air conditioner condenser (1). Clean the fins. If the steam jet nozzle is brought too close to the radiator fins, it may damage the fins. Keep the nozzle a suitable distance away from the fins when cleaning. 6. Work under the following rough conditions: Injection pressure: . . . . . . . . . . . . . . . . . . Max.
9.8 MPa (1420 psi) Nozzle diameter: . . . . . . . . . . . . . . . . . . . . . . . .Max. 2 mm (0.1 in) Distance between nozzle and radiator fins: . . Min. 100 mm (3.9 in) 7. Use an air jet nozzle to blow out all the mud and dirt, that has dropped down, to the front of the machine. Use an air jet nozzle, also, to blow the mud and dirt, that has accumulated on top of the fuel tank, to the front of the machine. It is also possible to use steam or water in place of compressed air. 8. Return condenser (1) to its original position and install bolts (2). WA250-6 3-43