OPERATION Brake Oil Temperature Caution Lamp The brake oil temperature caution lamp (1) illuminates to warn the operator that the brake oil temperature has increased. When carrying out the check before starting (starting switch at the ON position, engine stopped) The lamp does not illuminate. During operation (engine running) In continuous heavy-duty operations or when traveling long distances downhill where the brake is used frequently, the brake oil temperature increases. The brake oil temperature caution lamp and the central warning lamp illuminate; the alarm buzzer sounds intermittently.
At the same time, “E02” is displayed on the top line of the character display and “BRAKE OVERHEAT” on the bottom line. Take the following action. Release the accelerator pedal to reduce the travel speed. Avoid using the brake. Do not keep the brake pedal depressed continuously; use the brake only intermittently. If use of the brake is reduced for a short time in this manner, the brake oil temperature decreases and the caution lamp goes out. Quick Coupler Operation Pilot Lamp (if equipped) The quick coupler operation pilot lamp (2) illuminates and the buzzer sounds intermittently when the quick coupler is released.
At the same time, “PIN DISCONNECT” is displayed on the bottom line of the character display. When releasing the quick coupler, press the quick coupler attachment switch to apply the lock, then operate the work equipment attachment lever. If this lamp is illuminated at any time except when the quick coupler is being released, there is a problem in the quick coupler solenoid actuation circuit. Stop the machine immediately in a safe place; stop the engine; then carry out inspection. 2-18 WA250-6