Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK WATER SEPARATOR, DRAIN WATER AND SEDIMENT 3 - 56 1. Open th chambe 2. Inspect risen to the marked lin 3. If the rin g has risen to the marked line, c arry out the procedure from Ste 4. Prepare a container to catch the draine d fuel and s et it under the wate r separator. the bottom of the fuel tank. g (5) at the top of the water separator. 5. Close fu el valve (6) at the bottom of th 6. Remove air bleed plu g (5) at the top of the water se parator. 7. Loosen drain valve (1 ) at the bottom o f the water s eparator, 8. 9. and drai Loosen Remove n the water a ring nut (2), th element (4) f nd sediment into en remove filter rom the separato 10.

Wash el ement (4) and filter case (3) in 11. Check e lement (4) an d replace it if it is damaged. 12. When in stalling elem order. opposite Tighteni 40 ± 3 N ng torque of ri ·m (4.1 ± 0.3 13. Loosen air bleed plu g (5) then Fill fil When th e fuel comes out from air bleed plug (5), tighten air bleed pl ug (5).