Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK OIL LEVEL IN HYDRAULIC TANK, ADD OIL WARNING 1. Check sight gauge (G) on the left side of the machine. The oil level should be between the H and L lines. NOTICE Do not add oil above the H line. This will damage the hydraulic circuit or cause the oil to spurt out. If oil has been added to above the H level, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from drain plug (P). 2. If the oil level is below the L line, add oil through oil filler (F) at the top of the hydraulic tank. REMARK The oil level will vary depending upon the oil temperature. Accordingly, use the following as a guide: Before starting operation:

Between H and L levels (Oil temperature 10 to 30 ° C (50 to 86 ° F)) Normal operation: Around H level (Oil temperature 50 to 80 ° C (122 to 176 ° F)) CHECK ELECTRIC WIRING WARNING CHECK FUNCTION OF HORN 1. Turn the starting switch to the ON position. 2. Confirm that the horn sounds immediately when the horn button is pressed. If the horn does not sound, contact your Komatsu distributor for repair. 3 - 57 When removing the oil filler cap, oil may spurt out, so turn the cap slowly to release the internal pressu re before removing the cap.

If the fuses frequently blow or if there are tra cesof short circuitson the electricalwiring, locate the c ause immediately a nd carry out repairs, or contact your Komatsu distr ibutor for repairs. s, dry grass, etc.) accumulate around the battery, they will cause fire, so always If flammable materials (dead leaves, twig remove such material immediately. Keep the top surface of the battery clean a nd check the breather hole in the battery cap. If it is clog ged with dirt or du st, wash the battery cap to clean the breather hole. Check for damage and improper capacit y of the fuses, and any sign of disconnection or s hort circuit in the electric wiring.

Check also for loose terminals a nd tighten any loosened ones. battery, starter and alternator, when checking. of inflammables on and around the battery and remove them, if any. in the battery, consult the Komatsu distributor in your territory. Pay special attention to the wiring of the Be sure to check that there are no piles of inflammables on and around the battery and r emove them, if a For the checkup and repairs of troubles in the battery, consult the Komatsu distributor in your territory.