Komatsu — CHECK BEFORE STARTING ENGINE

. OPERATION OPERATION CHECK OF JAW CRUSHER 3 - 58 ADJUSTMENT OF REAR VIEW MIRROR rear view mirror (1) and Loosen the bolts securin g t he square mirro nd those securing the round rea r view mirror (2), and t hen adjust the mirror positions so that there will be no blind spot at the rear a nd left side of t he machine and a better view will be a vailable. No. Check Item Check Interval Method Standard Value Corrective Measure Daily Weekly Monthly 1 Abnormal vibration of machine { Visual check, Spanner - Stop and check. Check crusher for loosened securing bolts. 2 Abnormal noise from machine { Hearing check - Stop and check. 3 Flow of crushed debris { Visual check - Check for excessive feeding.

Limit feeding amount. Adjust grizzly feeder setting amount dial and crusher charge setting dial. 4 Abnormal heating of bearings { Feeling check Less than 120°C (248°F) (converted to 45°C (113°F)) Stop and check, if temperature is abnormally high. Check greasing amount is proper. 5 Abnormal noise from bearings { Hearing check None If any abnormality is noticed, stop and check. Repair or replace. 6 Loosening of bolts { Spanner No looseness Retighten. 7 Wear of fixed jaw plate { Visual check - Reverse or replace. 8 Wear of swing jaw plate { Visual check - Reverse or replace. 9 Wear of cheek plate { Visual check - Replace. 10 Wear of protector { Visual check - Replace.

11 V-belt Degree of tension { Try to press by hand - Check tension. Slip { Visual check - Pay attention to isufficient tension and misalignment. Wear and damage { Visual check - Replace. 12 Adding grease { Grease pump - Add.