Komatsu — OPERATIONS AND CHECKS AFTER STARTING ENGINE

. OPERATION OPERATION 1. After the warming-up operation is completed, check that each gauge and monitor lamp is in the following condition: Radiator coolant level monitor (1): Is monitor out? Engine oil level monitor (2): Is monitor out? Battery charge monitor (3): Is monitor out? Fuel level monitor (4): Is green color displayed? Engine coolant temperature monitor (5): Is green color displayed? Engine oil pressure monitor (6): Is monitor out? Engine coolant temperature gauge (7): Is indicator in black range? Fuel gauge (8): Is indicator in black range? Engine pre-heating monitor (9): Is monitor out? Air cleaner clogging monitor (10): Is monitor out? 2.

Check for abnormal exhaust gas color, noise, or vibration. If any problem is found, contact your Komatsu distributor. 3. If air cleaner clogging monitor (10) is lighted up, clean or replace the element immediately. For details of the method of cleaning the element, see "CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT (PAGE 4-23)". 3 - 76 WARMING-UP OPERATIO N IN COLD WEATHER OPERATION) h an automatic warming-up device. if the engine coolant temperature is low (below 30 °C (86 °F)), the warming-up atically.

operation is canceled if the engine coolant temperature reaches the specified (AUTOMATIC WARMING-UP This machine is equipped wit When the engine is started, operation is carried out autom The automatic warming-up specified temperature (30 °C (86 °F)) or if the warming-up operation is continued for 10 minut es. If the engine c oolant temperature or hydraulic oil t further as follows. emperature are low after the automatic warming-up operation, warm the engine up up NOTICE uddenly before the warming-up operation is completed. Do not accelerate the engine s uddenly before the warming-up operation is Do not run the engine at low id ling or high idling for more than 20 minutes.

This may cause oil le akage from the turbocharger oil supply pipe. If it is necessa ry to run the engine at idling for more than 20 minutes, apply a load or run at a mid-range speed from time to time. Do not carry out operations wh ile the hydraulic oil is still at low temperature . Always continue the warming-up operatio n until the hydraulic oil temperature monitor display is green.