Komatsu — OPERATION OF WORK EQUIPMENT

. OPERATION OPERATION When numeral input switch (3) is pressed, the scale goes down in When numeral input switch (2) is pressed, the scale goes up in direction (B). (A) Charging ratio at minimum (MIN): Whole scale is reduced in Guideline for adjusting scale SOFT HARD Adjusting method for grizzly feeder speed,crusher speed and crusher chamber charging amount 1. Basically, the jaw crusher speed is set to the maximum (MAX). 2. Visually inspect the charge amount in the crushing chamber, and if it is found more or less than 60%, adjust it by the crusher load setting dial. 3.

When crushing boulders or many big lumps contained in the debris, reduce the grizzly feeder speed as well as the jaw crusher speed for attaining higher work efficiency. 4. Feed debris into the hopper, aiming at 50% charging of the hopper capacity, and good hopper efficiency is assured and debris screening efficiency can be also heightened. REMARK The grizzly feeder speed and the jaw crusher speed will also vary with the engine rpm. 3 - 94 REGULATING CHARGING AMOUNT IN CRUSHER CHAMBER (Crush er load set di When directi numeral input on (A). di rection (B) Charging ratio at maximum (MAX):

Whole i The optimum charging rate for the cru n direction (B sher c hambe 60%, considering th consumable parts in e allowable the crusher work a chamb This machine is eq uipped with a functio n (excess cha rge preventi ve function). Howev er the timing that th e automatic fe eder stops fe eding is likel y to va ry according to the size and hard ness of debr is to be crushed an d their muck conte nt, resulting in ctual charge the cr ushing chamb Keep watching the charging rat r starting the e in th e crushing chamber for about an hour afte work, and adjust crusher charg e setting dial t o the optimum condition.