. OPERATION OPERATION Check and tighten the part The 1st time Thereafter After 4 hours Every 100 hours Tightening torque for bolts used in jaw crusher Unit: N · m (kgf · m, lbft) BACK LASH ON FIXED JAW PLATE An amount of backlash at the fixed jaw plate may increase at the initial stage of machine operation or right after replacement or reversal of the fixed jaw plate (within 30 hours). This is largely due to deformation of the fixed jaw plate at the securing portion. If this happens, check again if the spring set length of the wedge bolts securing the fixed jaw plate is within the specified limit. If not, tighten the wedge bolts again.
If backlash at the fixed jaw plate cannot be corrected, detach the plate, then completely remove dirt and sand stuck to the backside of the plate and the frame and install it again. 3 - 100 RETIGHTENING OF BOLTS AFTER WORKS Each par t securing bolt is likely to loosen at the initial machine securing bolts based on the following table, after the loaded operation is commenced.
The 2nd time The 3rd time After 8 hours After 50 hours Bolt Size Target Value N·m (kgf·m, lbft) Tolerance N·m (kgf·m, lbft) Major Applicable Points M10 65.7 (6.7, 48.5) 58.8 - 73.5 (6.0 - 7.5, 43.4 - 54.2) M12 112.8 (11.5, 83.2) 98.1 - 122.6 (10.0 - 12.5, 72.3 - 90.4) M16 279.5 (28.5, 206.1) 230.5 - 289.3 (23.5 - 29.5, 170.0 - 213.4) Toggle seat holding BKT M20 549.2 (56.0, 405.0) 456.0 - 568.8 (46.5 - 58.0, 336.3 - 419.5) Protector securing bolt, toggle block holding BKT M24 926.7 (94.5, 683.5) 784.5 - 980.7 (80.0 - 100.0, 578.6 - 723.3) Cheek plate securing bolt, (fixed jaw plate & swing jaw plate wedge bolts) 1716.2 (175.0, 1265.8) 1520.0 - 1912.3 (155.0 - 195.0, 1121.1 - 1410.4) M36 2745.9 (280.0, 2025.2) 2451.7 - 3040.1 (250.0 - 310.0, 1808.3 - 2242.2) Crusher securing anchor bolt M42 5325.0 (543.0, 3927.5) 4256.1 - 6393.9 (434.0 - 652.0, 3139.1 - 4715.9) Tension spring rod tip, (spring side of tension spring rod) M64 6825.4 (696.0, 5034.2) 5462.3 - 8188.6 (557.0 - 835.0, 4028.8 - 6039.6) Bearing cap bolt