Komatsu — EFFICIENT USE OF JAW CRUSHER

. OPERATION OPERATION USAGE OF JAW CRUSHER GRAIN DISTRIBUTION, ADJUSTMENT OF CRUSHER OUTLET CLEARANCE AND CRUSHABLE AMOUNT in direction a adjust in the can be pieces are 3 - 106 DEFINITION OF "UND ER 40" to 40 mm (0 to 1.6 in) shown in the catalog indicates a grain size distribution in which the The grain size of 0 maximum size of the crushed concrete block is 50 mm (2.0 in) in diamete r and and con crete blocks sm aller than 40 mm (1.6 in) acco unt for approx. 95% of all. ADJUSTMENT OF CRUSHER OUTLET CLEARANCE Clearance xx mm (x x in) means the dimension whe n the discharge port cl earance is ope ned to the max imum.

In the case of 50 mm ( 2.0 in) clearance, if the size of t he discharged crushe d material is co ncrete, with a new tooth plate, muck bar ope ning of 50 mm (2.0 in), and muc k content approx. 30% , it is more or l ess possible to obtain 40 and under. e particle distribution is generally described as follows. e distribution = discharge port clearance - 10 mm (0.4 in) The dimension of th e particle distribution is generall y described as follows Dimension of particl e distribution = discharge port c learance - 10 mm (0.4 GRAIN DISTRIBUTIO N The shape of the dis charge port of the jaw crusher i the diagram on the right.

It is possible to adjust (amplitude stroke of crusher), but it is impossible to vertical direction and in direction b (width of crusher Therefore, square-s haped materials such as con crushed to give a pro duct of 0 to 40 mm (0 to 1.6 in) nearly 95% when th e setting is 50 (OSS). Howeve rock with close grain , when crushing with the jaw cru cracks along the g rain, so large amounts of fla discharged from the crusher discharge port and the oversize material inc reases. The proportion change the strength of the g rain in natural rock.

In such ca mm (0 to 1.6 in) is n ecessary, use the optional vibra NOTICE If many large pieces ca n be seen in the piled material after crushing, this is becaus e the coarser th e pieces are, the smaller the density becomes and t hese appear on the surface. Norm ally, there are more smal ler pieces than it appears by loo king at the surface. CRUSHABLE AMOUN T nt shown in the catalog is a value measured under the condition of the best adjustment. In The crushable amou order to gain the pra ctical value in the ordinary crush ing work, therefore, it is recommend ed to multiply th e catalog value by work coeffi cient of 0.6 to 0.75.