. OPERATION OPERATION DETERRING WEAR ON JAW PLATES CAUSE FOR PREMATURE WEAR The outlet clearance and silica content particularly exercise a big influence among several factors listed above. PREVENTION OF PREMATURE WEAR Considering the efficiency, the best method is not to make the discharge port clearance extremely small but to adjust it to a larger dimension and to use a sieve. This is the ideal method because it increases the service life of the fixed jaw plate and movable teeth. For concrete rubble, keep to 50 mm (2.0 in) as the minimum clearance of the jaw crusher. PRECAUTIONS WHEN OPERATING JAW CRUSHER PRECAUTIONS IN OPERATION 1.
Adjust the grizzly feeder so that the crusher chamber will not be filled more than 80% at the most (approx. 60% on average). Never fill up the crusher chamber. If the feeding rate is too high, abnormal wear develops on the center to upper part of the fixed and swing crusher plates. In addition, an excessive crushing force will become necessary, so this may result in damage to the crusher itself. 2. Try to feed a large chunk of debris or a concrete block containing many reinforcing bars toward the end of the day's operation, because they are highly likely to disrupt the work by stopping the machine. PREPARATION FOR DEBRIS AS RAW MATERIALS 1.
Break up the rubble to a size of less than 1000 x 900 x 475 mm (39.4 x 35.5 x 18.7 in) before feeding it into the hopper. If there are large amounts of rubble at the maximum size, the productivity will drop. (In the case of natural rock, break up into sizes of 425 mm (16.7 in) square.) 2. Debris should not contain so much water that it becomes muddy. 3. Preferably reinforcing bars should not be included in the debris to be crushed for better working efficiency. (They tend to narrow the clearance at the outlet, thereby reducing the discharging efficiency) 4. For good work efficiency, debris may well be mixed in the debris to be crushed at the rate of 20 to 30%.
(If this ratio is higher than that, debris serves as a cushion in the crusher chamber, lowering the work efficiency. Moreover it causes premature wear on the fixed and swing jaw crusher plates) 5. Do not allow impurities (wood, paper, etc.) to get mixed in the debris to be crushed. Otherwise they can clog the outlet, and lowered debris discharge may lead to a damage on the crusher and toggle plate. 3 - 107 Advanced Delayed Outlet clearance Narrow Wide Water content Plenty Scarce Muck mixing ratio Plenty Scarce Sio2 content in silica Plenty Scarce Rock hardness Hard Soft