Komatsu — LOADING, UNLOADING WORK

. OPERATION TRANSPORTATION TRANSPORTATION TRANSPORTATION PROCEDURE LOADING, UNLOADING WORK WARNING 3 - 122 Select the m ethod of trans portation to match the weight and dimensions gi ven in "SPE CIFICATIONS ( PAGE 5 -2)" Note that th e weight and d imensions given in S PECIFICATIONS may dif fer accordin gto other When load ing or unloadin g the machine, run the e ngine at low idling and travel at low speed. When load ing or unloadin g the machine, park a tr ailer on a level and solid road bed. Moreover keep a good distance between the road shoulder a nd the machine. Make sure that ramps have sufficient width, length and thickness, and securely fi x them, inclined at less than 15°.

If an earth mound is emplo yed, firmly compact it so that the slops will not collaps e. ud or oil on the undercarriage beforehand so that the ill not slip off sideways on the ramps. Remove m machine w ill not slip off sid eways on the ramps. Furthermo re remove water , snow, ice, grease, oil, e tc. from the ramps, too. Never try t o change the travel direction on the ramps. Otherwise the ill slip off them. the ground or the trailer bed once, and then change the erate any other lever than the travel control lever on the of gravity of the machine suddenly shifts forward at the machine w ill slip off them. Return to direction. Do not op ramps.

The center connecting point of the ram ps and trailer bed, throw ing the machine off the balanc e. Pass it slowly for safety. Be sure to install after unlo ading the rear view mirr or, handrails, step, etc. that w ere removed wh en the machine was load ed. Don not start a work witho ut them, becau se it is dangerous, leadi ng to an accident. When loadin g or unloading , always use ramps o r a platform. Proceed as