Komatsu — STARTING MACHINE AFTER LONG-TERM STORAGE

. OPERATION LONG-TERM STORAGE LONG-TERM STORAGE DURING STORAGE WARNING AFTER STORAGE 3 - 132 BEFORE STORAGE e for a long time, do as follows. When pu tting the machine in storag e for a long time, do as f Clean and wash all parts, then sto re the machine indoors. If the machine has to be store d outdoors, s elec t level ground and cover the machine wi th canvas. oisture from collecting. re storage. ls of the battery and cover it or remove it from the machine and store it osition. Fill the fuel tank.

This prevents m Lubric ate and change the oil befo Discon nect the negative termina Set th e travel lock to the LOCK p Coat t he exposed portion of the p iston rod of the hydraulic cylinder (primary c onveyor u p/dow n cylinder, muck discha rge conveyor stowing cylin der (if equipped), lock cy linder) w ith grease. To pre vent corrosion, be sure t upercoolan antifre eze (density between 30% If it is nece ssary to perform the rust-prev ention operation while the m achine is indoors, ope n the door s and w indows to im prove ventilation and prevent gas poisoning.

Operate t he engine and move the m achine for a short distanc e once a month so t hat a new film of oil will be c oated over mov able parts and component surfaces. At the same ti me, also charge the battery. NOTICE If the mac hine has been stored without carrying out the monthly ru st-preven tion operatio n, consult your K omatsu distributor before usi ng it. When us ing the machine after long- term storage, do as follo ws befor Wipe o ff the grease from the hyd raulic cylinder rods. Be sur e to apply oil and grease to all the parts requiring lu brication When the machine is stored for a long period, moisture in the air w ill mix with the oil.

C heck t he oil befor e and after s tarting the engine. If there is water in the oil, chang e all the oil. STARTING MACHINE AFTER LONG-TERM STOR When starting the engine for the f irst time after a long stor age peri od, observe the following p rocedures. 1. Turn the starting switch key to t 2. Turn the fuel control dial from th e low idling (MIN) positio n to the f ull speed (M AX) position, an d hold on at that positi on for three seconds. Then return the dial to the low idling p osition and start the engine .