Komatsu — METHOD OF TOWING MACHINE

. OPERATION TROUBLESHOOTING METHOD OF TOWING MACHINE WARNING 3 - 134 Serious injury or deat h could result if a disabled m achine is towed incorrectly or if there is a mistake in the selection or insp ection of the wire rope. Always check that th e wire rope used for towing has a mple strength for the weight of the ma chine being towed. Never use a wire rop e which has cut strands (A), redu ced diameter (B), or kinks (C). There is operation. danger that the rope may break during the towing gloves when handling wire rope. on a slope. Always wear leather gloves when handling wire rope.

Never tow a machine During the towing o peration, never stand between th e towing machine and the machine bei ng towed. Operate the machine slowly and be careful not to appl y any sudden l oad to the wire rope. NOTICE The max, allowable pull of this machine is 176,000N(18,0 Do not attempt to pull a nything beyond this limit. If the machine sin ks in mud and cannot get ou t under i ts o wn power, or if the dr tow a heavy objec the right. Adjust putting ang awbar pull of the excavator i s being u sed to t, use a wire rope as shown in the diagram on le of the wire rope to 15° or less so that the the wire rope should and pull it.

not come in contact with the conveyer frame Put a wooden bloc k between the wire rope and the machin e to prevent possible d amages on the machine and the rope . Hold the wire rope level and direct it straight to the track frame. When towing a m achine, travel at a speed of le ss than 1 km/h for a distance of o carrying out repair This is for use onl nly a few meters to a place th at is suitable for s. y in emergencies.