. OPERATION TROUBLESHOOTING IF BATTERY IS DISCHARGED WARNING Do not charge the battery when the battery is installed on the machine. 3 - 135 This is dangerous. Before inspecting or handling th e battery, stop the engine and turn the key in the starting switch to the OFF position. s, so there is danger of explosion. Batteries generate hydrogen ga Never smoke or bring any flame c lose to the battery. Also be careful not to cause any spark. The battery electrolyte is dilute sulphuric acid, and it will attack your clothes or skin. If you get any battery electrolyte on your clothes or large amounts of fresh water.
skin, wash it off immediately with If it gets into your eyes, wash imm ediately with fresh water, then consult a doctor for treatment. When handling the battery, wear protective glasses and rubber gloves. When removing the battery, re move the ground side (normally the en installing the battery, install the negative (-) terminal) first. Wh positive (+) terminal first. If any tool touches between the p ositive terminal and the chassis, it will cause a spark. This is dangero happen. If the terminal is loose, there i us, so be careful not to allow this to s danger that defective contact may xplosion. e sure to tighten it securely.
generate a spark and cause an e When connecting the terminal, b When removing or installing the battery, be sure to confirm the positive (+) terminal and negative (-) term inal. REMOVE AND INSTALL BA TTERY remove the ground cable (normally connected to the negative (-) terminal). Before removing the battery, remove the ground cable (normally connected to the neg If any tool touches between t he positive terminal and the chassis, there is a hazard of sparks being generated When installing the battery, c onnect the ground cable last. ecure it with battery hold-down. battery terminal:
9.8 to 14.7 N·m (1 to 1.5 kgf·m, 7.2 to 10.8 lbft) When replacing the battery, s Tightening torque:Tightening battery terminal: 9.8 to 14.7 N·m (1 to 1.5 kgf·m, 7.2 to 1 PRECAUTIONS FOR CHAR GING BATTERY If t he battery is charged improp erly, it may explode. Accordingly, charge it according to "IF BAT TERY IS DISCHARGED (PAGE 3-135)" and the instruction man ual attached to the charger, and observe the following items. Set the voltage of the charger to match the voltage of the battery to be charged. If the correct v oltage is not selected, the charger may overheat and cause an explosion.
arger clip of the charger to the Connect the positive (+) ch positive (+) terminal of the bat tery, then connect the negative (-) charger clip of the charger t o the negative (-) terminal of the clips securely. battery. Be sure to attach the