. OPERATION TROUBLESHOOTING STARTING ENGINE WITH BOOSTER CABLE When starting the engine with a booster cable, do as follows: PRECAUTIONS WHEN CONNECTING AND DISCONNECTING BOOSTER CABLE WARNING 3 - 136 Set the charging current to 1/ 10 of the value of the rated battery capacity; when carry ing out rapid charging, set it to less than the rated batter y capacity. If the charger current is too hi gh, the electrolyte will leak or dry up, an d this may cau se the battery to catch fire and explode. If the battery electrolyte is fro zen, do not charge the battery or start the engine with a different power source. ll ignite the battery electrolyte and cause the battery to explode.
There is a danger that this wi ll ignite the battery electrolyte and cause the battery to Do not use or charge the batt ery if the battery electrolyte level is below the LOWER LE VEL line. Thi s may cause an explosion. Check the batte ry electrolyte level periodically an d add d istilled water to bring the electrolyte level to the UPPER LEVEL line. When connecting the cables,nev er contact the positive (+) and negative (-) terminals. When starting the engine with glasses. a booster cable, always wear safety Be careful not to let the normal m achine and problem machine contact each other. This prevents spar ks from generating near the battery en gas given off by the battery.
If cause serious injury. which could ignite the hydrog hydrogen gas explodes, it could Make sure you do not make a mis take in connecting the booster cables. Make the final connection to the engine block, be aware that sparks might be generated when this is done, so connect to a place as far as possible from the battery. (Howe ver, avoid connecting the cable to the work equipment, as conduction i s poor.) bles from the machine that has been Use care when removing the ca started. To avoid hydrogen expl osion, do not allow the cable ends to contact each other or the machin e. NOTICE The starting system on this mach ine is 24 V.
Always use a 24 V machin e for th e normal machin Always use a booster cable or cli p of a thickness that is suitable for the size o f the battery. For the battery on the normal ma chine, use a battery with the same capacity a s the problem ma Check that the cable and clips ar e not damaged or corroded. h machines are at the LOCK position. utral position. Connect the clips securely. Check that the lock levers of bot Check that all levers are at the ne