. MAINTENANCE OUTLINE OF SERVICE 4 - 5 FUEL and if fuel containing water or dirt is used, it cannot work properly. get in when storing or adding fuel. ration and Maintenance Manual. The fuel pump is a precision instrument, and if fuel containing water or dirt is used, it cannot wor Be extremely careful not to let impurities Always use the fuel specified in the Ope Fuel may congeal depending on the tem perature when it is used (particularly in low temperature below -15° C (5°F)). It is necessary to use the fuel tha t is suitable for the temperature.
To prevent the moisture in the air from co ndensing and forming water inside the fuel tank, always fil l the fuel tank after completing the day's work. Before starting the engine, or when 10 mi nutes have passed after adding fuel, drain the sediment a nd water from the fuel tank. If the engine runs out of fuel, or if the filte rs have been replaced, it is necessary to bleed the air fro m the circuit. COOLANT AND DISTILLED WATER Coolant is diluted for use, but always us e distilled water or city water (soft water) when diluting it .
River water and well water (hard water) contain mine rals (calcium will or magnesium) in large quantities, and t his will cause scale to form inside the engine or radiator . Once scale has formed, it is difficult to remove it, resultin g in defective heat exchange, which will lead to overhea ting. To avoid this, we recommend using water with a har dness of less than 100 PPM/liters when diluting the co olant. This machine is filled with Komatsu genu ine super coolant (AF-NAC) at the factory. This super co olant has the important function of preventing corrosio n in the cooling system as well as preventing freezing.
As a general rule, we do not recommend use of any coolant other than the Komatsu super coola nt (AF-NAC). If any other coolant is used, it may cause serious problems with the engine and cooling system. used continuously for two years or 4000 hours. e particularly careful to keep it away from flame. fers according to the ambient temperature. AN INSIDE OF COOLING SYSTEM (PAGE 4-28)". ne to cool before adding coolant.
Komatsu genuine super coolant can be The undiluted coolant is flammable, so b The mixing ratio for the super coolant dif For details of the mixing ratio, see "CLE If the engine overheats, wait for the engi If the coolant level is low, it will cause over heating, and will also cause problems with corrosion due t o air entering the coolant. GREASE oises at the joints. Grease is used to prevent seizure and n This construction equipment is used und er heavy-duty conditions. Always use the recommende d grease and follow the change intervals and recomme nded ambient temperatures given in this Operation and Maintenance Manual.
The nipples not included in the MAINTEN ANCE section are nipples used when overhauling, so the y do not need grease. ise after being used for a long time, grease it. is pushed out when greasing. If any part becomes stiff or generates no Always wipe off all of the old grease that Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts.