. MAINTENANCE SERVICE PROCEDURE WHEN REQUIRED CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT WARNING CHECKING If air cleaner clogging monitor (1) of the monitor panel flashes, clean the air cleaner element. Replacing 4 - 23 When using compres sed air, there is danger of d irt flying and causing person al injury. Always wear protecti ve glasses, dust mask, or ot her protectiv e equipment. When removing the o uter element from the air cle aner body, it is dangerous to p ull it out by force. W hen working in high places or where the foothold is poor, be careful not to fa ll because of the reaction wh en pulling out the o uter element.
Replacing elemen If one year has p cleaner clogging t, O-ring assed since installing the element or if air monitor (1) on the monitor panel flashes the element is cleaned, replace the outer ment, and O-ring. or valve immediately after element, inner ele Replacing evacuat Replace it if it is da maged or the rubber is markedly def ormed. NOTICE Do not clean the air clea ner element until the air clea ner clogging monitor on the monitor panel flashe s. If the element is cleaned frequently before the clo gging monitor flashes, the air cleaner wi ll not be able to display its performa nce fully, and the cleaning efficiency will also go do wn.
eaning operation, more dirt stuck to the element will fall inside the inner element. In addition, during the cl eaning operation, more dirt stuck to the element will fall inside the inner ele METHOD OF CLEANING OUTER ELEMENT 1. Open the door at (2), then remove . Open the door at the rear left of the machi ne, remove 4 hooks cover (3). g the element, do not leave or keep it in direct NOTICE Before and after cleanin sunlight. . Hold the outer ele ment (6), rock it lightly up and down a nd to the left and right, and rotat e the element to the left and right to pull it out.