Komatsu — CHECK, CLEAN AND REPLACE AIR CLEANER ELEMENT

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE of the air cleaner body (7). 5. Remove any dirt or dust that is accumulated to evacuator valve (4) installed to cover (3). 4 - 24 NOTICE Never remove th e inner element (5). It w ill allow dirt to e nter and cause failure of the en gine. ewdriver or other tool. Do not use a scr 3. After removin g the outer element (6), cover the air connector inside the air dirt or dust fr cleaner body with a cl ean cloth or ta pe to prevent om entering. 4. Wipe off or b rush off the dirt stuck to cover (3) a nd the inside 6.

Direct dry co mpressed air (less tha n 0.69 MPa (7 kgf/cm2 , , 99.4 PSI)) to the direct it from 1) Remove has been 2) Replace times rep inner ele outer element from i nside along i ts folds then outside along its fold s and again fr om inside. one seal from the ele ment wheneve r the element cleaned. the outer element which has been cleaned 6 6 eatedly or used thro ughout a year. Replace the e. the ment at the same tim