. MAINTENANCE SERVICE PROCEDURE INSTALLING ELEMENT 4 - 26 NOTIC Do not use any damaged gasket or Cleaning the element or O-ring after one year has passed and using them ag ain will cause problems. Always r eplace them with new parts. The seal portion on imitation parts lacks precision, and allows the entry of dust, which le ads to damage of th e engine. D o not use such imitation parts. Do not run the engine with the inne r element removed. It will cause damag e to the engin 1. C heck that there is no dirt or o il stuck to the seal portion of the ne w element o r cleaned element . Wipe of f any rt or oil. 2.
W hen the outer element has b een removed, check that the inner element ha s not com e out of position a nd is t at an angle. If inner eleme nt is at an angle, insert your hand and push it i n straigh 3.
P ush the outer element in stra ight with your hand when installing it to the air cleaner the outer element is held an d rocked lightly up and down and to the left and r ight whil e pushing it in, the outer ement can be inserted easil NOTIC E When inserting the element, if the rub ber at the tip is swollen or the outer e lement is not pushed in straight, and cover (3) is assembled by force to hook (2), there is danger that the hook and air cleaner body may be damaged, so be careful when assembling. 4. Install cover (3) as follows. 1) Align cover (3) with the element. 2) Hook the tip of hook (2) to the protruding part of the air cleaner body and lock it in position.
3) When locking hooks (2) in position, apply the hooks in turn on opposite sides (top, bottom, left, right) in the same way as when tightening bolts. 4) Always install cover (3) so that the evacuator (5) is facing the ground (A). 5) When cover (3) is installed, check that the clearance between the air cleaner body and cover (3) is not too large. If it is too large, install again. when 4. In ) Align cover (3) with the el ) Hook the tip of hook (2) t cleaner body and lock it in ) When locking hooks (2) in on opposite sides (top, bo as when tightening bolts. ) Always install cover (3) so the ground (A). ) When cover (3) is instal