Komatsu — CLEAN INSIDE OF COOLING SYSTEM

. MAINTENANCE SERVICE PROCEDURE CLEAN INSIDE OF COOLING SYSTEM WARNING *: Permanent type antifreeze shall meet the requirements of ASTM D3306-03. Stop the machine on level ground when cleaning or changing the coolant. The coolant has the important function of preventing corrosion as well as preventing freezing. Even in the areas where freezing is not an issue, the use of antifreeze coolant is essential. Komatsu machines are supplied with Komatsu Supercoolant (AF-NAC). Komatsu Supercoolant (AF-NAC) has excellent anticorrosion, antifreeze and cooling properties and can be used continuously for 2 years or 4000 hours. Komatsu Supercoolant (AF-NAC) is strongly recommended wherever available.

To maintain the anticorrosion properties of Supercoolant (AF-NAC), always keep the density of Supercoolant between 30% and 68%. When deciding the ratio of antifreeze to water, check the lowest temperature in the past, and decide from the mixing table given below. It is actually better to estimate and temperature about 10 ° C (18 ° F) lower when deciding the mixing ratio. The mixing ratio depends on the ambient temperature, but it should always be a minimum of 30% by volume (antifreeze/total amount of coolant x 100). The freezing temperature of undiluted antifreeze is -15 ° C (5 ° F). Do not store undiluted antifreeze at a temperature of below -15 ° C (5 ° F).

Stop the machine on level ground when cleaning or changing the coolant. Super coolant provides corrosion resistance effect in addition to preventing freezing. The mixing ratio differs according to the ambient temperature, but a minimum of 30% by volume is needed. When deciding the proportions for mixing the coolant with water, investigate the minimum temperature in the past and use the table below to decide the mixing ratio. In fact, set a temperature that is 10 ° C (18 ° F) lower than the minimum temperature. The freezing temperature of 100% undiluted super coolant is -15 ° C (5 ° F). Be careful not to keep undiluted super coolant at temperatures below -15 ° C (5 ° F).

4 - 28 The en gine cool ant is still at h igh t emperature right after the engine is stopped and the radiato r interior is pressurized.If the radiat or cap is lo osened unde r suc h conditions , the hot water spurt s out, causing a serious burn. Wait unt il the t emperature cools down and turn the cap s lowl y to release t he intern al pressure. Start t he engine for cleaning. Whe n leaving the machine , while the engine i s running, set t he t ravel lever safety lock to the LOCK position. engine, see the sections of "CHECK BEFORE STARTING ENGINE (PAGE 3-51)" and "STARTING ENGINE OPERATION of Operation in this manual.

un without the undercover, there is the danger that you may touch the rotating fan. is running, never get close to the rear of the machine. For st arting the engine, EFORE (PAGE 3-70)" in OPERATION o f Operation in th is manual If the e ngine is r un without the undercover, the re is the d ange r that you may touch the rotating fan. When the engine is running, n ever get close to the rear o f the machine. and "STARTING Wash th e inside of the coolin g system and c hange th e coolant (antifreeze) a ccording t o the table below.

Antifreeze coolant Interval of cleaning inside of cooling system and changing antifreeze coolant Komatsu supercoolant AF-NAC Every two years or every 4000 hours whichever comes first. Permanent type antifreeze (All season type, *) Every year (autumn) or every 2000 hours whichever comes first.