Komatsu — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE CHECK AND ADJUSTMENT OF JAW CRUSHER CHECK AND ADJUSTMENT OF OUTLET CLEARANCE the distance value for the smallest clearance as the representative value. REMARK rod of the dimension (A) (B) Crusher discharge port clearance Lock cylinder (C) (D) Fixed jaw plate Swing jaw plate 4 - 35 CHECK OF OUTLET CLEARANCE Discharge port clearance (A) (opening end) means Discharge port cl from t he tip of the fixed jaw plate to the bottom of the m when the c rusher discharge port is fully open. Measure a t three places (both ends and the center) When measuring discharge port clearance (A), it is c use a jig a s show n in the example below. (Example) Length = approx.

1500 mm (4 ft 11 in), di = φ6 to 10 mm at both ends. Weld commonly used discharge port clearanc (for ex ample: 50 mm (2.0 in)) to an H-sha