. MAINTENANCE SERVICE PROCEDURE OUTLET CLEARANCE ADJUSTING METHOD A (Automatic): The clearance is automatically adjusted according to the set value input on the clearance set monitor. WARNING ENGINE When adjusting the discharge port clearance, use the inching (A): Adjustment range (B): Flywheel marking (red painted part) 4 - 36 When the machin e is used continuously, wear of the tooth tip will cause the cr usher dischar ge port clearan ce to become larger, an d the size of the particle will becom e coarser. If the crushed p article s are re markabl y worse than when the clearanc e was last adjusted, ad just the clearance as follows.
The crusher disch arge port clearance is a djusted by extending or retracting the lock cylinder On this machine, there are three types of clearance adjustmen t function S (Semi-automati tomatically desir clearance set monito is -, the clearance be r. (If the input value is +, the clearance becomes lar ger; if th e input value comes smaller.) M (Manual): It is p ossible to adjust the cle arance manually by u sing the panel s witch Start the engine. For adjusting the outlet cle arance, set t he travel lev er lock to the LOC K position with out fail.
Be sure to attach a warning tag to the starti ng switch in the control For starting the engine, see the sections o f "CHECK B (PAGE 3-70)" in O peration of OPERATION i n this manua operation to bring the position of the flyw heel to the center of t adjustment range discharge port cle