. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 5. Set clearance adjustment selector switch (3) to the M (manual) position. of the machine monitor has switch (4) and crusher adjust so that crusher actual clearance monitor (A) for the amount to change the present clearance reaches the target value. (4) Crusher clearance decrease switch Action to close crusher clearance continues while switch is REMARK Depending on the wear of the teeth, the value after compensation may not become exactly 0, but this does not indicate any abnormality. 4 - 43 6. Check th at mode monitor (D) to M (manual) mode. changed 7. Using cr usher clearance decre pressed.
(5) Crush er clearance increase Actio being n to open crusher cleara nce continues while sw pressed. REMARK er is operated, the teeth become worn, so the value displayed on clearance display monitor (A) As the crush gradually be comes different from th e actual clearance. W hen this happens, it i s possible to compensat e for the value by kee ping crusher clearance decrease switch (4) pr essed to bring the te eth into conta ct with the fi xed jaw plate. 1. Keep crus her clearance decrease switch (4) pressed to b ring the movable teet h and fixed ja w plate into contact. When the value (A) shows no mo re change, the movabl e teeth and fixed jaw plate are in c ontact. 2.
After bring ing the movable teeth and fixed jaw plate into contact, keep crush decrease s witch (4) pressed fo r approx. 10 seconds. 3. The buzze r sounds and the comp ensation is completed. When this happens, the value on crusher actual clearan ce monitor (A) chang 4. Press crus her clearance increase switch (5) and adjust s o that the value on cru sher actual cl earance mo nitor (A) becomes t