. MAINTENANCE SERVICE PROCEDURE CHECK OF WEAR ON MAJOR WEARING PARTS JAW PLATE WARNING CAUTION Hatched portion (1): Virtual wear range reaches NOTICE bolts also at the same time. 4 - 44 When checking the wear, sto p the crusher, then stop the engine a If the machine is used con tinuously with the crusher chamber e xcessively charged, pr emature partial wear wil l develop on the tips of jaw plates. If a work is continued wi th the partially worn jaw plates, rocks may not be discharged smoothly, eventually resulting in s on account of the worsened partial wear. jaw plates with new ones. ond their wear limit, a serious damage will be inflicted on the jaw crusher main body itself.
damages on the jaw plate s on account of the worsened partial Replace the partially worn If jaw plates are used bey ond their wear limit, a serious damag e will be inflicted on th e jaw crusher main bod If the bottom tips of fixed a nd swing jaw plates have been w and reached the wear limi t as illustrated in the figure at right reverse or replace them, (A) Were limit for fixed ja w plate: 55 mm (2.2 in) (thicknes (2.9 in) (B) Wear limit for swing ja w palte: 60 mm (2.4 in)(thicknes REMARK The bottom part of the fra me at the fixed jaw plate mountin g surface protrude ((A) - (C) = 25 mm (1.0 in CHEEK PLATE Carry out replacement w approx. 15 mm (0.6 in) (w ear amount:
10 mm (0.4 in)) at t and approx. 10 mm (0.4 i bottom. When replacing the cheek pl ate, replace the cheek plate mountin