Komatsu — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE of the clearance on both sides of fixed and position the fixed jaw plate and the crusher frame so that both centers are aligned. 4 - 49 1. Dismantle t he cheek plates, refer with the che ek plate replacement. 2. Remove th wedge lock Tools to us (1) Extensio n socket: Supplied too (2) Ratchet handle: Supplied tool (3) Extensio n pipe: Supplied tool N 3. Lift up the fi xed jaw plate with a wi When re once. Th insert it in When re block on rope and When re versing the fixed jaw p en hook a wire rope on t he other side to lift it up and to the crusher frame. jaw plate, lower it on to a When re placing the worn fixed a ce.

Then lift up a new fixed jaw plate with a wire er frame. insert it into the crush 4. jaw plate, a 5. If the fixed j aw plate (3) is not in ti ght contact with the frame, 6. insert wood en block (or equivalent part) (1) between fix ed jaw plate (3) an Push out th d swing jaw plate (2). e swing jaw plate (swi ng jaw) (2) and push fixed e. adjusting discharge port jaw plate (3 ) against the front fram For details , see Method for 7. Install the fix ed jaw plate wedge bo lt and fixed jaw p late wedge 8. lock. Set fixed ja w plate wedge bolt spring (A) to 108 to 110 mm 3 in). heek plates. (4.26 to 4.3 Install the c