. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE 2. Reduce the length of turnbuckle (3) of the crusher motor bracket. 4 - 56 5. Remove only one toggle se at holder plate ( 3) at the fixed link end. Screw in 6. plate ha s been removed provision ally, taking care no 7. When th e work of lifting up the toggle seat been co mpleted, proceed he opposite side. plate on t 8. Insert ey ebolts into both en ds of the toggle seat at t he toggle block end , then raise the to (Weight o f torque seat at to ggle block end: 40.0 kg (88 lb)) 9. Insert ne w toggle seats in t he reverse orde r of the w orks explained above. REPLACEMENT OF CRUSHER DRIV 1.
Loosen th e bolts of flywheel cover (1) at the side of th e top step to releas e it, and at the sam e time, remove motor c over (2).