. MAINTENANCE SERVICE PROCEDURE REPLACEMENT OF TOGGLE SEAT WARNING CAUTION 2. Remove toggle seat holder plates (1) of the swing jaw at both ends. (Bolts to use: M20 x 8) 3. Screw in eyebolts (M12) into tap hole (2) at both ends of the toggle seat and fit the wire. 4 - 55 Before replacing th e toggle seat, follow the item s below without After long use, th e toggle seat becomes defo rmed, so it may g et stuck t o the fixed link or swing jaw. In this case, weld a hook to the center of t he toggle seat and pull out t he worn toggle s eat.
In addition, if ne cessary, take action with the gasket or o ther part a (Toggle seat mat The toggle seat has no interchangeability, s o be careful not t o mistake the combination when instal Toggle seat at s wing jaw end: Amount of pro trusion and protrudin g parts: 32.5 mm (1.3 in) (center p art), protruding part is a bottom. Toggle seat at fix ed link end: Amount of pro trusion and protruding parts: 47 mm (1.9 in), protruding To prevent the to ggle seat at the fixed link e nd from falling, e xtend the lock cylinder fully when carr 1. Start with rem the section de manual. oving the toggle plate beforehand, referring to aling with replacement of the toggle plate in this 4.
Raise the tog ggle seat at swing jaw en d: 44.3 kg (98 l