. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE AND ADJUSTMENT OF OUTLET 4 - 54 23. Install tightening len Set so that the tighteni ng length (C ) of th e tension spring is 258 to 260 mm (1 0.17 to 1 0.24 i n) whe n the lock cylinde r length is the minimum. 24. Install the rub ber cove r (x 1 ) on to p of t he toggl e plate. (M12 b olts x 4 25. Loose n the ch ain bloc k installed to the b ottom of the swing jaw and remove t he wire. 26. Close the cru sher inspectio n hatc h and secure with bolts. 27. Install the dus tproof r ubber plate t o the side of t he c rusher. 28.
Check crushe r outlet clearance (A ) and adjust it to a desired clearance For adjusting the crusher o clearance, se of CLEARANCE (PAGE 4-35)