Komatsu — CHECK AND ADJUSTMENT OF JAW CRUSHER

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE WARNING 4 - 53 It is extremely dangerous if you go on to t he next work without completely loosening ten sion spring (2), so remove t ension spring nut (M42) from the rod. 9. Loosen t ension spring (2) (both ends: M42) completely. (1) Singl e-ended wrench: Suppli (2) Exte nsion pipe: Supplied tool 10. Pass the wire through the hole in the bottom of the swin g jaw then use a chain block to pull th e crusher case and the track se switch (5) on the contro slowly. track frame an d fix them in position. engine. usher clearance increa 11. Start the 12. Press cr box, and pull back the fixed link 13. Stop the engine. 14.

Take ou (Weight of toggle plate: 101 kg ( 15. Wrap a nylon sling around the n 16. Lower th e toggle plate and align it with the center of the seat 17. Start the engine. 18. Set the operation mode selector switch to the INSPECTION 19. Attach a worked 20. Push the crusher clearance decr ease switch on the control b ox, push out the fixed link , and adjust the lifting weight o f the wire at the same tim e, then set in position so that the center of the contact surface at the front of the togg le plate is aligned with th e center of the contact 21. Stop the engine. 22. Remove the nylon sling fitted to t