. MAINTENANCE SERVICE PROCEDURE clearance of 30 to 40 mm (1.2 to 1.6 in) from the lower surface of the magnet on the main body. 3) In case debris are stuck at the backside of the belt; Remove them as soon as found, since they can cause a damage on the belt or the pulley. 4) If the belt or any related part is broken, replace it immediately. 4 - 62 Have metal parts or or bolts at the connetion of the belt end not been damaged or fallen o If anything unusual is found, take the following actions. d or makes a snaky movement; e take-up unit, referring to the unit consists of a base plate, a lt.
Loosen the lock bolt on the position of the take-up unit with justment, tighten the lock bolt arance more than 10 mm (0.4 in) r surface of the flange at the end a proper position. not appropriate; the same way as mentioned t the belt so that it will have a ADJUSTING CLEARANCE FROM CON VEYOR een V-belt surface of the belt ), (B) = 350 mm (13.8 in). cording to the condition of the ce. The standard clearance betw conveyor and the magnet is (A Change this as necessary ac crusher discharge port clearan