. MAINTENANCE SERVICE PROCEDURE (It is in even contact with the belt across the width) INSPECTION AND MAINTENANCE OF MAGNETIC SEPARATOR WARNING CAUTION structure as that for the conventional belt conveyor. Pay 4 - 61 DRIVEN PULLEY SIDE If t he scraper rubber has been worn out, replace it by securing bolts. There is danger that the magnetic field may cause ma lfunction of pacemakers, so persons wearing pacemakers sh ould not approach within a range of 5 m (16 ft 5 in) from the ma gnetic separator.
The magnetic force will attract metal tools and pieces of steel, and there is danger of getting your fingers or hand s caught between such objects and the attracting surface, so d o not approach the magnetic separator when carrying meta l tools or pieces of steel. Use a steel object removal belt to remove any pieces of steel attracted to the magnetic separator. There is danger of injury, so do not approach the magnetic separator while it is bei ng operated. When storing this machine or removing the magnetic separator, set up cones and make a no entry area. Do not allow any person wearing a pacemaker to approach within a ran ge of 5 m (16 ft 5 in) from the magnetic separator.
lignment or snaking of the belt. re is danger that the belt will be damaged or cut. Before starting operations, check that there is no misa If there is any misalignment or snaking of the belt, the There is danger of the magnetic field causing damage, s o do not bring watches, cellular phones, or other precision ins truments close to the magnetic separator. There is danger of the stored data being damaged by th e magnetic field, so do not carry bank cards, credit cards, or ot her cards with magnetic strips when approaching the magnetic separator. When conduction a trial run of the machine, be sure to run tha motor at low speed and check that the conveyor belt does not make a snaky movement.
If metal pieces are drawn by tha magnetic separator, th ey will be ejected, accelerated by the metal piece dischargin g belt. As that poses a big danger, provide a safety cover at the discharging outlet to prevent the metal pieces from flying off. Do not feed concrete debris containing reinforcing bar s larger than 13 mm (0.5 in) in diameter and longer than 600 mm (23.6 in), since they can damage the conveyor belt. The discharging belt for this machine has the sa attention to the following points, when starting the Has the belt been biased or doe it make a snaky Is the belt tension appropriate? Are debris stuck to the backside of the belt?
Has the belt surface been scratched or peeled o Has the belt scraper not been damaged?