. MAINTENANCE SERVICE PROCEDURE idling, loosen drain hose (1), and bleeding operation, tighten drain idling, loosen drain hose (1), and bleeding operation, tighten drain 4 - 64 METHOD FOR RELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCUIT For details, see "STARTING EN GINE (PAGE 3-70)". If it is necessary to refer to the items for starting the engine, moving the machine off, steerin g, or stopping, see the OPERATION s 1. Bleeding air from pump 1) Loosen air bleeder (1) the air bleeder. 2) If the oil does not ooze o hydraulic pump case a with hydraulic oil throug Hold the removed hos higher than the oil level i not spill out of the hose.
3) After completing the bleeder (1) and install th NOTICE l will spurt out from bleeder hole (1). If the drain hose is installed first, oi If the pump is operated without filli ng the pump case with hydraulic oil, abnormal heat will be generat ed and this may cause an unexpected damage to the pump. 2. Starting engine Start the engine, referring to "STARTING ENGINE (PAGE 3-70)". Run the engine at low idle f or 10 minutes after starting, then start 3. Bleed air from crusher moto 1) Run the engine at low i check that oil oozes out 2) If no oil oozes out, stop t and fill the inside of the 3) After completing the air hose (1).
4) Run the engine at low id 1) Run the engine at low i 4) Run the engine at low id 4. Bleed air from grizzly feede 1) Run the engine at low i check that oil oozes out 2) If no oil oozes out, stop t and fill the inside of the 3) After completing the air hose (1). 4) Run the engine at low id 1) Run the engine at low i 4) Run the engine at low id