Komatsu — METHOD FOR RELEASING INTERNAL PRESSURE IN HYDRAULIC CIRCUIT

. MAINTENANCE SERVICE PROCEDURE MAINTENANCE SERVICE PROCEDURE hose (1). NOTICE 5 minutes before starting operations. This 4 - 65 5. Bleed air from conveyor NOTICE Whe n bleeding the air from the c onveyor motor, prepare a suitable stand (ladder, etc.) to use when carryin g out the operation. (Height of con veyor motor from g round: 3.0 m (9 ft 10 1) Run t he engine at low idling, loose n drain ho se (1) at the ection port, and check that oil oozes out from drain (1). drain 2) If no oil oozes out, sto p the engine, r emove dr ain hos e (1), ill the inside of th e motor case with hydraulic oi 3) After drain 4) Run t he engine at low idling to rota te slowly. 6.

Bleeding air from travel m otor the oil inside the travel motor case w idling, loosen air bleeder (1), and s out. (Bleed th has been 1) Run tighte Bleed th e air only when has been drained.) the engine at lo 1) Run n it when oil flow stop releases the bubbles in the oil in the tank. Check that there is no oil leak age and wipe of f any spille After compl eting the air bleedi ng operation, c heck the oi l level, a nd add oil if