. MAINTENANCE SERVICE PROCEDURE REPLACE FUEL FILTER CARTRIDGE WARNING 4 - 74 EVERY 500 HOURS SER Carry out periodic maintenan ce work of every 100 and 250 hours of operation at the sam The engine is at high temperat ure immediately after the machine has b een operated. Wait for the engine to cool down before replacing the filter. Do not bring fire or sparks nea Prepare a filter wrench and a container to catch the fuel. the fuel under the filter cartridge. filter cartridge (1) counterclockwise a new filter cartridge with clean fuel. with engine oil. Then install the new der. cartridge until seal comes in contact tighten approx. 2/3 turn.
htened too far, the packing will be ad to leakage of fuel. If the filter el will also leak from the packing, ect amount. er cartridge, bleed the air from the system. (to the position where the float is at the highest position). dge (1), loosen air bleed plug (2). 1. 2. 3. 4. 5. 6. 7. 8. 9. 1. Set the container to catch 2. Using a filter wrench, turn filter cartridge (1) counterclockwise on remove it. 3. Clean the filter holder. Fill a new filter cartridge with clean fuel. Coat the packing surface with engine oil. Then install the new cartridge into the filter hol der. 4. When installing, screw in cartridge until seal comes in contact with sealing surface, then tighten approx. 2/3 turn.
htened too far, the packing will be If the filter cartridge is tig damaged and this will le filter cartridge is too loose, fu always tighten to the corr 5. After replacing the fuel filt er cartridge, bleed the air from the s ystem. Bleed the air as follows. 6. Fill the fuel tank with fuel (to the position where the float is at 7. After replacing filter cartri dge (1), loosen air bleed plug ( 2). 8. Loosen the knob of feed p ump (3), operate it up and down, an d continue until no mor e bubbles come ou t with the fuel from air bleed plu g (2). (2). cartridge is recommended for use. 9.
Tighten air bleeding plug A genuine Komatsu filter cartridge is recommended for After finishing the replace ment of the filter cartridge, start the e ngine and check that th ere is no oil leakage from the filter seal surface.