. MAINTENANCE SERVICE PROCEDURE CHECK OIL LEVEL IN FINAL DRIVE CASE, ADD OIL WARNING 4 - 75 The oil s till remains a t high temperatur e just aft er an operatio n is f inished. Start the job after the oil t emperatur e cools down If pressu re is left in th e final driv e case, oil may spurt ou t or th e plu g may fly off. Loosen the p lug slo wly to relie ve the interna pressure Prepare 1. Set th e TOP mark at the to p, with the UP mark and p lug (P) perpendicula r to the groun d surface 2. Remo ve plug (F) u sing the handle . When the oil level reaches a poin t 10 mm (0. 4 in) belo w the bottom of the plug hole, the correc t amount of oil has b een ad ded. 3.
If the oil level is t oo low, i nstall plug (F levers, and drive forward o r in re verse t o rotate one tu rn. Then re peat Step 2 to c heck a gain. 4. If the o il level is lo w, add en gine o il throu gh plug hole (F) unti the oil overflows f rom plug hole ( 5. After c hecking, in stall plug