. MAINTENANCE SERVICE PROCEDURE CLEAN HYDRAULIC TANK STRAINER WARNING cause burns. Wait for the NOTICE 4 - 84 immediatel to go down befo re startin g the work. When remov ing the oil filler c ap, turn i t slow ly to releas e the internal pressure, t hen remove and ma 1. Remove 4 bolts, then r emove cover (1). Whe n doing this, cover (1) the cover may fly off because of the f orce of sp keep pushed down when removin g the bolt 2. Hold the strainer ( 3. Remove any dirt stuck to straine r (4), then was h it in flushing oil. If strai ner (4) is damaged, replace it with a n ew part. 4. When ins talling, insert str ainer (4) into protruding part (5) o f the tank, and assemble. er (1) with bolts.
5. Install cov er (1) with bolt CLEAN, CHECK TURBOCHARGER Contact your Komatsu distributor for cleaning and i nspection CHECK ALTERNATOR, STARTING MOTOR Wear on the b rush and the b earings short of grease are suspected, so ask th e Komatsu distributor i n you r territory for the repair s. If the engine is started frequentl y, shorten the p eriodic che ck interva l to every 100 0 hours o CHECK ENGINE VALVE CLEARANCE, ADJUST As special to ols is required f or removing and adjust ing the p arts, you should reques t service from your Komatsu distributor.
CHECK VIBRATION DAMPER As special to ol is required fo r removing an d adjustin g the parts, you shall request Komatsu d istributor fo r service.