. MAINTENANCE SERVICE PROCEDURE CHANGE OIL IN FINAL DRIVE CASE WARNING REMARK 4 - 83 EVERY 2000 HOURS SERVICE Maintenance for every 100, 250, 500 and 1000 h ours s hould b e carried out a t the same tim The component parts and oil are warm ed up to high temperature j ust after an operation. A casual touch wil l cause a burn Hence start the replacement job after t he temperatur e cools down. If pressure is st ill left in the case, oil m ay spurt out, or the p lug may fly off. Rel ease the internal resi dual pressure by t urnin the plug slowly Oil replaceme nt amount: 305 liters (0.92 US g al)(bot h let an Prepare a ha 1.
Set the TOP mark at the top, with the TOP m ark an d plug ( perpendicula r to the ground surfa 2. Place an oil receiving container u nder plug (P 3. Remove plu gs (P) and (F), using a handle, to drain Check an O-ring fitted to the plug for any damag e, and replace with new one, if 4. Tighten plug 5. Add oil throu gh the hole of plug ( 6. When oil be gins to overflow from the plug (F) hole, i nstall pl (F). Tightening torque of plugs (P) and (F): 68.6 ± 9.8 N·m (7 ± 1 kgf·m, 50.6 ± 7.2 lbft)