Komatsu — REPLACE HYDRAULIC FILTER ELEMENT

. MAINTENANCE SERVICE PROCEDURE REPLACE HYDRAULIC FILTER ELEMENT WARNING engine is stopped, and may cause burns. Wait for the 4 - 82 temperat ure to go down before When rem oving the oil filler cap , turn it slowly to release the intern 1. Move t he machine to flat, f irm ground and stop th e engine . 2. Remov e the cap from oil filler (F), and release the internal re. 6 bolts, then remove cover (1). When doing this, the may fly out under the force of spring (2), so hold the own when removing the bolts. moving spring (2), valve (3) and strainer (4), take out t (5). 3. pressu Loosen cover cover d may fly out under t own when removin 4. After re moving spring (2), t (5).

elemen Insp if an hydr elemen Insp ect the bottom of th e filter case for dirt, an d remov e it, y. Take good care aulic tank. then not to let fall the dirt into the diesel oil. the 5. Clean t he removed parts in 6. Install t he new element in t he place where old elem ent (5) w as installe d. 7. Set val ve (3), strainer (4) a nd spring (2) on top of t he element. 8. Set cov er (1) in position, p ush it down by hand, an d install the cover w ith the mouning bo lts. nd install the cover. engine according to "STARTING 9. Screw in the oil filler cap a 10. To ble ed the air, start the STARTING ENGIN E (PAGE 3-70)" and run the engine at low idle for 10 s. e engine. 10 minute 11. Stop th